Sometimes projects require the fence panels to be angled in varying degrees outside of 90°. This article will detail how the rails can be adjusted to accommodate for an alternate angle.

Our semi-permanent Zippity fences use joiner clips to attach the panels together. The length of a joiner clip will allow you to place the panels flush against each other or place them at an angle.

HOW TO:

1. Put the rails level, side by side, at the desired angle. 
2. Place the joiner clip with one end on each rail. 
3. Attach the joiner clip to the rail with screws. 
4. This application should allow any angle. 

You can also use hinges as shown above for our semi-permanent fences. The hinges would need to be attached directly to the rail. Hinges and paint need to be purchased separately at your local hardware store and should be no larger than 1” wide.